Connecting Power; Connecting The Ieee1394 Cable - JVC KY-F1030 Bedienungsanleitung

2. Before shooting (continued)

Connecting power

Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA
terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided.
AA-P700
AC 100V
S(Y/C) OUTPUT
White marking
AC
Connect the end with
the white marking to
the AC adapter.
CAUTION
• Be sure to use the AA-P700 power supply.
Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF.
Connecting with the power switch on may result in camera malfunction.
• When connected through the digital output (Connecting through digital output connector (page E14)),
power can be supplied from the PC but control of a motorized lens and analog output will not be
possible.
MEMO
Wait at least 10 seconds before turning the power switch back on, when it has just been turned off.
Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.

Connecting the IEEE1394 Cable

E18
AC adapter
DC 12V=OUTPUT
VIDEO OUTPUT
TO CAMERA
EITHER SEE INST-
OUTPUT RUCTION
MAX 1.25A MANUAL
[TO CAMERA]
connector
power cable
(provided)
To [IEEE1394]
connector
ANALOG OUT
IEEE1394
LENS
MD
CONTROL
REMOTE
DC IN
POWER
SEE INSTRUCTION MANUAL
[DC IN] connector
To reduce the emission of unwanted radio waves,
make sure to attach the provided clamp filter as
shown in the figure on the left.
Attach the clamp filter as close to the KY-F1030 as
possible as shown in the figure.
Ring
Plug
After inserting the plug com-
pletely, tighten the securing
ring.
Make sure white indication of
power cable comes to AA-
P700 side.