Function Setting Switch; [Menu] Button - JVC KY-F1030 Bedienungsanleitung

Part names and their functions (continued)
[Side switch panel section (inside)]
MENU
1 2 3 4

[MENU] button

Press this button to output the menu screen
through the [ANALOG OUT] connector
Press again to stop display of the menu.
Setting procedure (
[UP/AW] auto white balance, UP
button
● [AW (auto white)]
Press this button to adjust the white bal-
ance when the light source illuminating
the subject changes.
White balance adjustment (
● [UP]
While the menu screen is displayed,
press this button to move up to a select-
able item on the menu. While an item is
selected, use this button to change the
set value.
Setting procedure (
UP/AW
SET
DOWN
page E32)
page E22)
page E32)
[SET] button
While the menu screen is displayed, press
this button to select a submenu or confirm
a selected item or set value.
Setting procedure(
[DOWN] button
While the menu screen is displayed, press
this button to move down to a selectable
item on the menu. While an item is selected,
use this button to change the set value.
Setting procedure(

Function setting switch

Used for setting the functions of the KY-
F1030.
ON
OFF
● Switch 1 <TEST PATTERN>
.
ON: Test signal is output.
OFF: The image being shot by the cam-
era is output.
Monitor adjustment (
SYSTEM SETTING screen (
● Switch 2 <MENU LOCK>
ON: Disables the [MENU] button
OFF: Enables the [MENU] button
● Switch 3 <SYNC ON GREEN>
ON: Applies the sync signal to the green
(G) channel of the video signal that
is output through the ANALOG
OUT connector º.
OFF: The sync signal is not applied.
● Switch 4 <RESERVED>
This switch is not used. Leave it at OFF.
page E32)
page E32)
1 2 3 4
page E21)
page E40)
.
.
E11