Pc Connection; Using The Video Output - VOLTCRAFT BS-1500T Bedienungsanleitung

11. PC CONNECTION

To transfer the recorded pictures and videos to a computer, you can connect your endoscope basic device to your
PC directly via USB.
Of course, there is the alternative option of removing the SD memory card from the device to transfer the pictures
and videos from the card reader to your computer.
Proceed as follows:
• Switch on the endoscope.
• Connect the USB cable to the mini-USB-socket B1 of the endoscope basic device.
• Connect the other end of the USB cable to a free USB port of your PC.
• The BS-1500T now acts as a card reader and your computer will recognise the memory card as a removable
drive.
• You can now copy files from the SD card onto the PC.

12. USING ThE VIDEO OUTPUT

Before you can use the video output, you always must have set the proper video format as described in chapter
9 d). Also observe the operating instructions for your Tv.
• First connect the 3.5 mm jack plug of the enclosed video cable to the Av socket C2 of the endoscope basic
device.
• The yellow cinch plug transmits the video signal. Connect it to the video input socket of your Tv.
• Connect the white cinch plug that transmits the audio signal to the corresponding cinch audio input of your Tv.
• Switch on the endoscope.
• Open the setting menu (A9) and navigate to the item "VIDEO OUTPUT".
• Push the button "OK" (A9), to switch the picture from the display of the endoscope to your Tv.
• To terminate display on your Tv, open the menu again and confirm with "OK" while the item "VIDEO OUTPUT" is
selected (A9).
Alternatively, disconnect the video cable between the endoscope and your Tv.
41