Initial Configuration Of The Network Settings - G&D MultiPower-12-NT Installationsanleitung

Initial configuration of the network settings

Initial configuration of the
network settings
Accessing the web application requires you to configure the network settings of the
device on which the web application is operated.
NOTE:
In the defaults, the following settings are pre-selected:
 IP address: address is obtained via
 global network settings: settings obtained using
How to configure the network settings before integrating the device into the local
network:
1. Use a category 5 (or better) twisted pair cable to connect the network interface of
any computer to the device's Network interface.
2. Ensure that the IP address of the computer's network interface is part of the sub-
net to which the device's IP address belongs to.
NOTE:
Use the IP address 192.168.0.100, for example.
3. Switch the device on.
4. Start the computer's web browser and enter the URL
5. Click on Download Config Panel
6. Authenticate your user account against the web application.
NOTE: Use the preset access data to log in to the administrator account:
 Username:
 Password:
Change the preset password of the administrator account. The manual of the
web application provides a detailed description of how to change the preset
access data.
7. Click the tools symbol in the toolbar.
8. Click the tabs Network > Interfaces
7 · G&D MultiPower-12-NT
.
Admin
4658
.
(fallback: IP address 192.168.0.1)
DHCP
DHCP
192.168.0.1 in the address bar.