Conditions Of Safe Use - Eaton ZEB XTOE Handbuch

Installation

Conditions of Safe Use

(controlled by Eaton
drawing 464-1024)
50
If one of the reactions does not occur, the overload relay
shall be taken out of operation and return to Eaton Corpora-
tion.
This could ether be done via the local contact person
(www.eaton.com/moeller/aftersales) oder under the
following number: +49(0)1805223822.
The following conditions apply to the installation, operation
and maintenance of the assessed equipment. Failure to
observe these may compromise the safety integrity of the
assessed equipment:
• The user shall comply with the requirements given in the
manufacturer's user documentation in regard to all rele-
vant functional safety aspects such as application of use,
installation out of hazardous areas, operation, mainte-
nance, proof tests, maximum ratings, environmental
conditions, and repair.
• Selection of this equipment for use in safety functions,
configuration, overall validation, maintenance and repair
shall only be carried out by competent personnel,
observing all the manufacturer's conditions and recom-
mendations in the user documentation.
• All information associated with any field failures of this
product should be collected under a dependability
management process (e.g., IEC 60300-3-2) and reported
to the manufacturer.
• The C440/XTOE/ZEB Electronic Overload relay shall only
be installed in non hazardous area where installation to
EUC can be implemented.
• The automatic restart using the "A-rest DIP switch" shall
not be configured for automatic reset to avoid spurious
trip due to un-cleared faults, hence, the automatic reset
mode will not be allowed and manual reset is required.
• The Modbus communication shall not be used to imple-
ment the safety function or neither used as an interface
with a DCS to implement a safety function if the safety
device self powered or external power applied.
10/13 MN03402007Z-DE/EN