Press the motor cover [3] evenly and se-
curely into place on the device (see Fig. A).
All 5 locking hooks must clip into place.
Press the cover [4] evenly over the housing
[1] until it clicks into place. Do not bend or
distort it.
8.3 Commissioning
Check that the shutter [6] operates easily
and that it is undamaged.
Activate mains fuse.
Carry out a function test.
9.
Maintenance
The device is maintenance-free.
10.
Cleaning
Danger to life, the device
is live!
Switch power off.
DANGER
Don't apply water to the
device.
Clean the device with a moist cloth.
11.
Fault rectification
● Always call on the services of a qualified
electrician in the case of faults.
● Repairs should only be carried out by
trained electricians.
Danger to life, the device
is live!
Switch power off.
DANGER
Fault
– Device doesn't run
– Thermal overload
motor protection
switches the device
off and back on again
after it cools down.
Tab. 1: Fault rectification
Measure
Identify the cause of
the fault and rectify it.
12.
Dismantling
Danger to life from electric
shock!
Switch power off.
DANGER
First pull off the lower third of the cover [4]
and then remove it.
Release all 5 locking hooks (see arrow] on
the motor cover [3] from their positions
using a screwdriver.
Remove motor cover [3].
13.
Disposal
Not in domestic waste.
i
The unit contains in part material that
can be recycled and in part
substances that should not end up as
domestic waste.
Dispose of the unit once it has reached the
end of its working life according to the
regulations valid where you are.
Assembly │ UK
13