Dometic MaCave S17G Bedienungsanleitung Seite 52

Using the appliance
Checking the set temperature
This is how to display the set temperature:
➤ Press the
✓ The set temperature is shown in the display for 5 seconds.
Then the display shows the current inner temperature again.
I
NOTE
In the event of an interruption to the power supply (power failure,
switch over) the unit saves the previous temperature settings.
Temperature monitoring
A warning signal sounds and the temperature display flashes.
z if the inner temperature of a zone deviates from the set temperature by
more than 5°C.
z if the power supply has been disconnected for a long time.
z if the door has not been shut properly.
z if the door is open for more than 60 seconds.
This prevents the temperature from falling or rising unnoticed, which could
affect the quality of the wine.
Once the unit has reached the set temperature, the warning signal stops and
the temperature display stops flashing.
To switch off the warning signal prematurely:
➤ Press the
✓ The temperature display flashes until the set temperature is reached. The
display is then illuminated constantly and indicates that the alarm system
is active again.
Using the Sabbath mode
In this mode, the display, interior lighting and warning signal for the temper-
ature monitor are deactivated. The refrigeration continues as usual.
To switch on the Sabbath mode:
➤ Press the
and
✓ The temperature display flashes 4 times. The Sabbath mode is activated.
The Sabbath mode switches off automatically after 96 hours.
52
or button briefly.
button briefly.
buttons simultaneously for at least 5 seconds.
MaCave
EN