PeakTech 2175 Bedienungsanleitung Seite 37

5.11. Continuity Check
WARNING:
To avoid electric shock, never measure continuity on circuits or
wires that have voltage on them.
Follow these steps to perform audible continuity test:
1. Set the function switch to the "
2. Insert the black test lead into the /CAP -input jack (-) for
Inductance measurements and the red test lead into /CAP
-input jack (+) for resistance measurements.
3. Press the "
the display.
4. Touch the test probe tips to the circuit or wire you wish to
check. The buzzer will sound if the measured resistance is
approximately 30 Ω and the middle secondary display will
show "Short" (for short).
"-button until the
/
-36-
"- position.
/
symbol appears in