D) Checking The Programming State - Solamagic S1 Montage- Und Gebrauchsanleitung

Checking the programming state
The following matrix makes it possible to recognise the programming status of the
wireless receiver according to the listed operating states. To do so, connect the
device as described in the installation instructions.
Unprogrammed
Mains Remains off
connection
Briefly press IIR tube is
any key switched on at low
level
Briefly press IR tube is
any key for a switched on at
second time high level
Heat
Programmed
Remains off
If a programmed
key:
On in the last
switching state.
Otherwise no
reaction
If a programmed
key: Switch off.
Otherwise no
reaction
33
Light (for S1 light module set)
Unprogrammed
Always on
Key 1–4:
no reaction but
reaction with key 5
Key 1–4:
no reaction
but reaction with
key 5
Programmed
Last switching state
prior to mains outa-
ge is called up
If a programmed
key:
On in the last
switching state.
Otherwise no
reaction
If a programmed
key: Switch off.
(Switching for duo-
light if right key)
Otherwise no
reaction
08/2016