Programming The Wireless Remote Control - Solamagic S1 Montage- Und Gebrauchsanleitung

Programming the wireless remote control

The control module or the heat-light combination unit is programmed in two sepa-
rate steps on the wireless remote control:
Step 1:
Step 2:
Assign a key on the hand-held transmitter for heat regulation.
A key pair (left and right) is also assigned for the duo-light control.
Only one key is additionally assigned for the mono-light control.
Important:
• Programming of the heat regulation
• Programming of the light control
• Only those heaters should be connected to the mains
that are to undergo programming to a hand-held trans-
mitter key. This allows the programming of several re-
ceivers (multi-power). Previously programmed devices
can remain connected to the mains.
• Use of other components with a wireless-signal inter-
face (e.g. wireless PC mouse and keyboard) may result
in faulty operation of the wireless receiver. Switch off all
other wireless components, particularly when program-
ming.
• T he wireless receiver is briefly disabled after command
entry using the hand-held transmitter.
29
08/2016