Herunterladen Inhalt Inhalt Diese Seite drucken

A) Heat Programming - Solamagic S1 Montage- Und Gebrauchsanleitung

Led-lichtmodulset
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Step 1: Heat programming: (WSS receiver)
Initial programming:
Multiple programming: It is possible to program radiant heaters on up to eight
Safety switch-off:
08/2016
The heater to be programmed is connected to the mains.
Brief pressing of the desired key 1 to 4 on the hand-held
transmitter triggers wireless receiver programming (hea-
ting tube starts at low level). Repeated pressing of the
same key confirms the programming (heating tube swit-
ches to top level).
If desired, time-out switching can be programmed by dou-
ble-clicking: If the programmed key is pressed briefly twi-
ce in succession, the heater will switch off in 30 minutes.
The heating tube activates for 2 seconds. Double-clicking
again increases the heating duration to 60 minutes (hea-
ting tube illuminates for 4 seconds). Double-clicking again
increases the shut-down to 90 minutes (heating tube illu-
minates for 6 seconds). Double-clicking once more swit-
ches the time control off. The programming cycle for time-
out switching begins again from the beginning.
Programming is ended by long pressing of the program-
med key of the hand-held transmitter. The heating tube
confirms that programming is completed by operating for
two seconds.
keys on one or more hand-held transmitters (multi-con-
trol).
Connect the relevant heaters to the mains. As described
under „Initial programming", the key to be programmed is
briefly pressed (heating tube starts at low level) and con-
firmed through repeated pressing (heating tube starts at
low level). Program the next key by pressing (heating tube
starts again at low level) and confirm (heating tube starts
at low level). This process is repeated until all the desired
buttons on all the desired hand-held transmitters are pro-
grammed.
The multiple programming is ended by extended pressing
of a key on one hand-held transmitter (heating tube extin-
guishes and restarts for 2 seconds).
The radiant heater always remains switched off after a po-
wer outage.
30

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis