B) Light Programming - Solamagic S1 Montage- Und Gebrauchsanleitung

Step 2: Light programming (the same for duo and mono light):
(Receiver LFD; LFDS; LTD; LTDS; FUE2)
It is recommended, that the light is programmed to a key (a key pair - left/right for
duo-light) that is not already programmed for a remote control.
First programming:
Multiple programming: It is possible to program wireless receivers on up to eight
The light to be programmed is connected to the mains.
The light switches on.
For light module set S1:
Switch to a programmable state by brief pressing of
key 5 on the hand-held transmitter. The program-
mable stage exists for 10 seconds and is indicated
by a short one-off flashing of the lights.
Now brief pressing of the desired key on the hand-held
transmitter triggers wireless receiver programming (low
brightness). Repeated pressing of the same key confirms
the programming (full brightness). This process is ended
by final long pressing of a key on the hand-held transmit-
ter (briefly low brightness, then full brightness). The light
wireless receiver is now programmed.
hand-held transmitters. The corresponding hand-held
transmitters with the consumers are connected to the
mains (light of the connected light components is switched
on). As described above under „Initial programming", one
key of a key pair to be programmed is briefly pressed (lu-
minaire dims down) and then confirmed through repeated
brief pressing (luminaire brightens). Then another key is
programmed by pressing (luminaire dims down) and sub-
sequent confirmation (luminaire brightens). This process
is repeated until all the desired keys (key pairs) on all the
hand-held transmitters are programmed. Multi-program-
ming is ended by long pressing (longer than 1 second) of
a previously programmed key on the hand-held transmit-
ter (LED luminaire flashes briefly).
31
08/2016