Safety And Operating Instructions - Solamagic S1 Montage- Und Gebrauchsanleitung

Safety and operating instructions

• Carefully read through the instruction manual prior to installation and store the
manual safely.
• Installation tasks must be properly carried out by a qualified person in ac-
cordance with VDE 0100 installation instructions.
• When carrying out any work on the electrical system, always switch to a zero-
volts state (pull out the plug, circuit-breaker off).
• Switch the devices on only after all cables have been fully connected.
• To operate the device, you need the Solamagic FUS 6 wireless remote control
which can be purchased from your distributor.
• Do not operate the wireless remote control together with inductive loads (fluo-
rescent lamps, discharge lamps, fans, etc.) in the same electrical circuit.
• Use of other components with a wireless-signal interface (e.g. wireless PC
mouse and keyboard) can result in faulty operation of the wireless receiver.
Switch off all other wireless components, particularly when programming.
• If damage to the Solamagic components occurs (e.g. supply cable, power
pack, etc.) switch the device to a zero-volts state. Repair or maintenance work
may only be performed by the manufacturer or a comparable trained person.
• Devices rated IP44 are approved for indoor and outdoor use.
21
08/2016