C) Reprogramming - Solamagic S1 Montage- Und Gebrauchsanleitung

Reprogramming
Selective deleting:
Complete deletion:
Note:
08/2016
Already programmed wireless receivers can be deleted
and reprogrammed using the corresponding hand-held
transmitter. To do this, press and hold buttons 1 and 2
of the hand-held transmitter simultaneously (longer than
3 seconds) until the red control lamp on the hand-held
transmitter illuminates. Deletion is now enabled. Now re-
lease the buttons and directly thereafter briefly press that
key with which the wireless receiver was operated up
until now. The control lamp on the hand-held transmitter
flickers briefly when the deletion signal is sent. The wirel-
ess receivers enter the on-state and then switch off and
on again. These receivers can now be reprogrammed as
described under „Programming" above.
This action deletes all receivers that are within range of
the hand-held transmitter.
Programmed wireless receivers can also be deleted (re-
set) upon loss of a hand-held transmitter or if it becomes
defective. The deletion process is only possible within
180 seconds of connection to the mains of the receiver in
question. (If necessary, disconnect the receiver from the
mains and then reconnect.)
To delete, hold buttons 1 and 2 of the hand-held trans-
mitter pressed down (longer than 3 seconds). When do-
ing so, the red control lamp on the hand-held transmitter
only illuminates once deletion is enabled. Now release the
keys and directly thereafter briefly press both keys simul-
taneously. The control lamp on the hand-held transmitter
flickers briefly when the deletion signal is sent. The wirel-
ess receivers enter the on-state and then switch off and
on again. These receivers can now be reprogrammed as
described under „Programming" above.
32