Configuration - VOLTCRAFT DL-200T Bedienungsanleitung

• The battery compartment (4) is on the back of the logger unit. Insert
a new and suitable battery (see "21. Technical data" on page 94)
into the battery compartment observing correct polarity (positive/+ and
negative/-).
• Slide the logger unit back into the housing. Ensure that the LC display
matches to the LCD window of the housing.
• Place the protective cap back onto the data logger.
The data logger performs best at room temperature. If the item is
used at extremely low temperatures, the battery life is reduced. In
such case, you can reduce power consumption of the data logger
in order to prolong the operation time as following
disable LC display
-
disable LED alarm
-
set a longer sampling rate
-
For details refer to chapter "11. Configuration" on page 69.

11. CONFIGURATION

After inserting a battery, configure the data logger either by software or by
website. Select logging parameters like sampling rate, start time, recording
time, pause function, LED flash interval, enable/disable LC display and PDF
report settings.
Configuration terminologies and commands may differ between
software and website.
The following instructions and explanations are based on the
terminologies and commands found on the configuration website.
After creating the configuration file, copy it to the data logger!
69