Silvercrest IAN 274301 Bedienungsanleitung Und Serviceinformationen Seite 30

SilverCrest SFB 10.1 C3
3. Press
"MACRO6" and press
4. The display reads "SET UP". Press
5. If you select a macro that already has a command sequence
assigned, the display reads "MACRO HAS". In this case you have to
delete this macro before entering commands or select a different,
free macro.
6. The device currently selected is shown.
7. Enter the command sequence you want using the buttons. Always
start with the device button for the device you wish to record the
macro for. The number of commands already entered is shown on
the left hand side of the display.
8. By default, the different macro commands are transmitted
sequentially every second. As this could be too fast for some devices,
you can adjust the delay time in 2-second increments from 5 to 41
seconds.
9. To do this, press the button
of the button delays the pause time after the last command for 2
more seconds and the set value is shown on the display.
10. After you have finished entering the command sequence, press
. The display reads "SUCCESS".
You can press up to 16 buttons per macro, including the device button.
After this, the macro is applied automatically and the display reads
"SUCCESS".
Example command sequence for programming a macro
You want to start by switching your television on. After a 21 second
pause, the satellite receiver is to be switched on as well. Switching the
satellite receiver on takes about 22 seconds. So you should enter a
delay time of 25 seconds. The next step is to select preset channel 32.
The command sequence to enter is as follows:


The delay time in this example are random and do not relate to the
devices to be controlled.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
28 - English
, select "MACRO1" (or "MACRO2".....
 Pause 21 Sec. (9 times
 Pause 25 sec. (11 times
 
to confirm.
to confirm.
after a button command. Each press
)
) 