Setting The Menu Language (Language); Programming The Remote Control (Code Setup); Brand Code Search (Brand Srch) - Silvercrest IAN 274301 Bedienungsanleitung Und Serviceinformationen

SilverCrest SFB 10.1 C3

Setting the Menu Language (LANGUAGE)

The "LANGUAGE" main menu item allows you to select the desired
language for the remote control. You can choose one of the following
menu languages: English, German, Italian, Spanish or French. Proceed as
follows:
1. Press and hold the
, select "LANGUAGE" and then press
Upon factory delivery the device is set to the English language. Therefore
the first option shown is "LANGUAGE".
2. Press
press to confirm. The display reads "SUCCESS".
Press to go back one menu level. To return to the start window,
press one of the device buttons (4).

Programming the remote control (CODE SETUP)

This main menu item allows you to program the remote control according
to your needs. The following 3 methods are available:
1. Brand code search "BRAND SRCH". If the manufacturer of your
device is in the device code list of the remote control, this is the
fastest programming method.
2. Automatic code search "AUTO SRCH". This method runs through all
the codes available on the code list and sends them to your device.
This method takes a relatively long time.
3. Direct code input "CODE SET". This method requires entering the
code found in the device code list manually.
The operating instructions below help you program the remote control
using any of the above programming methods.

Brand code search (BRAND SRCH)

1. Press the device button of the device that you want to program.
2. Press and hold the
3. Press
16 - English
, select one of the 5 languages offered and then
Before programming a device button by using brand
code search or automatic search, please carry out a
"RESET" for this device button. If this device had
previously been programmed using the learn function,
any learned keys would not be overwritten by the new
programming. For more information, see the chapter
"Resetting to factory defaults (RESET)" on page 24.
, select "CODE SETUP" and press
button for 3 seconds. Press
button for 3 seconds.
.
to confirm.