Automatic Filter Cleaning; Storing The Appliance; Transport; Storage - Kärcher NT 75-1 Originalbetriebsanleitung

Illustration
 Remove the elbow from the suction
hose.
 Attach the stepped power tool adaptor
to the suction hose.
Illustration
 Connect the adaptor to the electric pow-
er tool.
Note: The different suction hose sections are
required to allow an adjustment to the con-
nection sections of the processing tools.
 Set the minimum volume flow for the
suction hose cross section at the rotary
switch.
The scale displays the suction hose cross
section.
Note:To use the appliance as dedusting
device for the mobile operation (processing
tool connected to the vacuum cleaner) the
built-in monitoring must be adjusted to the
connected processing tool (dust-generat-
ing device). This means that the user must
be warned if the minimum volume flow of
20 m/s that is required for the suction is fall-
en short of.
Note: Please refer to the type plate for the
specification of the minimum volume flow in
dependence on the negative pressure.

Automatic filter cleaning

The appliance has an innovative filter
cleaning system that is particularly effective
with fine dust. The flat pleated filter is auto-
matically cleaned every 15 seconds
through an air jet (pulsating sound).
Turn off the appliance
 Switch off the appliance at the rotating
knob.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
22
Fold the push handle in/out
 Loosen the fastening screws of the
pushing handle and adjust the pushing
handle.

Storing the Appliance

Illustration
 Store the suction hose and the mains
cable as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
Ensure proper fastening of the device dur-
ing transportation.
You need to take the following measures
for dust-free transportation of the device:
 Wipe the suction hose and the accesso-
ries with a damp cloth.
 Place the suction hose with attachment
in the delivered transport sack. Close
the transport sack
 Close the suction connection, see wet
vacuuming.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
– 5
EN

Transport

Storage