F) Manual Brightness Settings (Rgb W); Test Mode; Operating Hours - Renkforce GM-313 Bedienungsanleitung

f) Manual Brightness Settings (RGB W)

This setting adjusts the basic brightness of the individual colours (red, green, blue and white) to each other.
At delivery, all colours are set to the same brightness value and usually do not need to be changed. Please
observe that the change to the brightness values will affect all operating modes.
• Use the button MENU to select the setting for the individual colours MAnu.
• Push the ENTER button.
• Use the buttons UP and DOWN to select the colour to be set, red (rEd), green (GrEE), blue (BLuE) or white (UhIt).
• Set the intensity of the brightness for the colour with the buttons UP or DOWN.
If all brightness settings have roughly the same value, the LEDs light up white. For setting 0, the single
colour is switched off.
• Push the ENTER button.
• Now adjust the next colour accordingly.
g) Test Mode
• Use the button MENU to select the setting tESt.
• Push the ENTER button.
The test run starts. The individual LEDs will light up in the different basic colours at short intervals. You can
check the function of the LEDs here.
• Push the ENTER button to end test operation.
h) Operating Hours
• Use the button MENU to select the setting FhrS.
• Push the ENTER button. The display shows the operating hours.
33