Migatronic SIGMA NEXT RC Betriebsanleitung Seite 19

Connection and operation
Switch on, press, weld
Welding program setting
• Switch on the welding machine on the main switch (2)
• Select welding program
1
MENU
9
# /9
2
PROG
See program table
• Adjust welding current and secondary parameters
QUICKGUIDE SIGMA NEXT RC
DK
Indstilling af MIG svejseforløbet - 9 Stopstrøm (%)
Process setup
10 Burn-back (0-30)
11 Eftergas (sek.)
14
12 Punkttid (sek.)
6
7
5 8 2
15 13 Indstillet strøm
4 9
3 12 10 11 14 Home/retur
16
Kort tryk på (14) = retur til menu. Langt tryk
13
på (14) = retur til driftsbillede.
17
15 Aktuel sekvens/sekvenser i alt
Maks. antal sekvenser i normal mode = 9
18 1
Maks. antal sekvenser i job mode = 99
19 16 Arc adjust
17 Puls
Til/frakobling af MIG pulssvejsning.
1 Indstilling af parametre 18 Gas
Drej på knappen for at indstille den ønskede
Gastest. Indstilling af manuel gas/IGC (ikke
parameterværdi.
alle modeller) + kalibrering af IGC.
2 Valg af svejseparameter
19 Genkald af fabriksindstilling
Drej på knappen for at vælge den ønskede Reset den valgte parameter til fabriks-
svejseparameter. indstilling.
3 Forgas (sek.)
4 Krybestart (m/min)
5 Hotstart (%)
6 Hotstarttid (sek.)
7 Slope-down (sek.)
8 Stopstrøm-tid (sek.)
side 1 af 4
• The machine is now ready to weld
WARNING
Voltage is present on the welding
wire when pressing the welding
hose trigger.
The quickguide helps you
select welding program
according to the welding
wire and shielding gas to
be used.
See quickguide
Multiple wire feed units
MENU
i
MENU
9
/9
9 15. #
/9
#
0.0
MENU
9
/9
#
6.2 m/min
125
Software reading
• Insert the SD-card
• Turn on the machine
• Wait until the remote unit indicates that the
update is complete.
• Turn off the machine and remove the SD card
• The machine is now ready for use.
All connected wire feed units and power sources will
be updated with the new software.
The software can be downloaded from
http://migatronic.com
Licence SW
If you purchase additional licences for programs or
special funtions, load the MigaLic.dat files like the
software packages. Note! Create a backup of the
files.
The MigaLic.txt file contains information about
licence number and licences saved on SD card.
RWF² 1 RWF² 2
1
MENU
15. 9 15.
/9
#
0.0
1
15.0
V
0.0 V
5.0 mm
A
2
0.0
19