Connection And Operation - Migatronic Sigma Next Rc Betriebsanleitung

Connection and operation

Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for later
use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply. Please
read the type plate (U ) on the rear side of the machine.
1
0
l
1
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required when
connecting earth cables and
welding hoses to the machine.
Lift instructions
(Lifting kit no. 78857054)
2
Robot / PLC setup
Migatronic's standard
configuration file
(10010205) is loaded in
SIGMA NEXT.
The SD card included in the
supply contains additional
configuration files and
setup files required by some
robots and PLCs. Load the
MIGA_CFG/ DOCUMENTS
folders on your PC. Each
folder contains EDS or GSD
files, user manuals, quick
guides and various Anybus
module documentation for
communication devices.
2
3
4
5
6
1. Mains connection
2. Power switch
3. Fieldbus module
4. Connection of intermediary cable and
remote control
5. Earth clamp
6. Earth clamp
1
F
F
F
Config.
MIGA_CFG
DOCUMENTS
Power
Devicenet
EtherCAT
Ethernet-IP
Profibus
Profinet
17