Programming Mode; Activating Programming Mode - Emitter Basic Bedienungsanleitung

2.1 Programming mode

Programming can only take place in the programming mode. For activation/deactivation
proceed as follows:
Step Activity

Activating programming mode

1
Press the
keep it pressed until the green LED is
flashing. The display shows „1" for the first
memory slot.
2 Deactivating the programming mode
Press the
The programming mode is terminated and
the device switches to standard mode:
If the programming is successful the green
LED lights up if all traps are set.
The red LED lights up if one or more traps
were triggered.
Important:
The programming mode stays active for 30 seconds if no key is pressed inbetween. During
this time programming must take place. If no input is made for 30 seconds (no key is pressed),
the programming mode is terminated automatically.
28
-key (see Fig. 1, Pos. 5) and
-key.
Explanation / Illustration