Programming - Emitter Basic Bedienungsanleitung

2. Programming

Before you can start programming, put the eMitter display into operation:
Step Activity
1 Putting the eMitter display into operation
Connect the eMitter display to a 230V-plug
socket. Connect the angle plug (see Fig. 1,
Pos. 2) to the connector socket at the
eMitter display (see Fig. 1, Pos. 4).
2 Display
The display shows the the program version
for 2 seconds.
3 Status indication
If the memory is empty the display shows
„00", and all three LEDs are flashing.
Explanation / Illustration
27