Indicator Lights; Overall Checking; Service And Maintenance - Daikin FWF02CATNMV1 Installationshandbuch

Kaltwasser-ventilatorluftkühler

Vorschau ausblenden Andere Handbücher für FWF02CATNMV1:

Installationshandbuch (15 Seiten)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

Inhalt

121

Inhaltsverzeichnis

Verfügbare Sprachen

Remote Control

When there is infrared remote control operating signal, the signal receiver on indoor unit will make a <beep> for signal

acceptance confirmation.

Error Description

Room Sensor error

Pipe water sensor error

Water pump error

Pipe water temperature fault

*Window open activated

*Antifreeze mode activated

*Load shedding activated

*Only applicable for 4-pipe system

• Ensure the following, in particular:-

1) The unit is mounted solidly and rigid in position.

2) Piping and connections are leak proof after charging.

3) Proper wiring has been done.

Drainage check:- Pour some water into left side of drain

pan (drainage are in right side of unit).

• Test run:

1) Conduct a test run after water drainage test and gas

leakage test.

2) Watch out for the following:-

a) Is the electric plug firmly inserted into the socket?

b) Is there any abnormal sound from unit?

c) Is there smooth drainage of water?

Note is valid for Turkey only: The lifetime of our products is ten (10) years

Service Parts

Indoor Air Filter

1. Remove any dust adhering to the filter by using a vacuum cleaner or

wash in lukewarm water (below 40°C/104°F) with a neutral cleaning

detergent.

2. Rinse the filter well and dry before placing it back onto the unit.

3. Do not use gasoline, volatile substances or chemicals to clean the filter.

Indoor Unit

1. Clean any dirt or dust on the grille or panel by wiping it using soft cloth

soaked in lukewarm water (below 40°C) with neutral detergent solution.

2. Do not use gasoline, volatile substances or chemical to clean the indoor

unit.

• Avoid direct contact of any coil treatment cleaners on plastic part. This may cause plastic part to deform as a result

of chemical reaction.