Indicator Lights - Daikin C-Serie Installationshandbuch

FAULT DIAGNOSIS
Wireless Controller
When there is infrared remote control operating signal, the signal receiver on indoor unit will
make a <beep> for signal acceptance confi rmation.
Wired Controller
If there is any abnormal condition detected, wired controller will blink the error code.
Event
1. Room Sensor Open or Short Blink 1 time
2. Indoor Coil Sensor Open
3. Outdoor Coil Sensor Open
4. Compressor Overload /
Indoor Coil Sensor Short /
Outdoor Coil Sensor Short
5. Low Refrigerant Charge/Gas
Leak/Outdoor Abnormal
6. Water Pump Fault
7. Outdoor Coil Sensor
(MS model)
8. Hardware Error
(tact switch pin short)
NOTE
Power LED = Cool/Dry/Fan LED, turns on in these modes
The unit will not detect sensor missing when the compressor is ON
Call your dealer immediately when this error happen
1 IM 5CKC-0912(0)DAIKIN-EN.indd 18 1 IM 5CKC-0912(0)DAIKIN-EN.indd 18

INDICATOR LIGHTS

Power LED Timer LED
-
Blink 2 times -
Blink 3 times -
Blink 1 time
-
- Blink 3 times Blink Cool & Dry
- Blink 2 times Blink Cool & Fan
- Blink 5 times Blink Cool & Heat
- Blink 6 times Blink Heat, Cool,
1-18
Other LEDs Error Code
Blink Fan Blink E1
Blink Sleep Blink E2
Blink Dry Blink E3
Blink Cool Blink E4
Blink E5
Blink E6
Blink E7
Blink E8
follow by Fan, Dry
10/9/12 9:42:54 AM 10/9/12 9:42:54 AM