Inhaltsverzeichnis
Werbung
SPRAYING
11 - Never point the spray gun to anyone or at any part of the body.
12 - Never throw or drop the electrostatic manual gun. Any misuse of the spray gun equipment or
accessories can damage them and result in serious body injury, fire or explosion.
13 - The parts to be painted must be properly grounded. Any incorrect electrical continuity might result in
stock hazard.
14 - Never operate the electrostatic spray gun if air leaks are detected on the gun. Never use air hoses
on which air leaks can occur.
15 - Be sure that tip and air cap are in position and hand tightened with the retaining ring onto the gun
before turning on the power supply.
16 - Verify that any person entering the spray area is correctly grounded with conductive sole shoes (in
accordance with EN 50 053 standard).
The operator must not wear gloves which insulate the hand from the conductive gun handle. If using
gloves, check that they are conductive (in accordance with EN 50 053) or that a square has been
cut-out in the glove palm.
SERVICING
17 - After any servicing or cleaning, never switch on the power supply tip and air cap are in position and
secured with the retaining ring onto the gun.
18 - Never immerse the gun or plastic parts of the gun in solvent.
This could seriously damage the gun and cause fire, explosion or body injury. To clean the gun use
soft cloth or bristle brush with a moderate amount of non-conductive solvent, wipe the front of the
gun at fluid nozzle with the gun pointed down to prevent from flowing back into the air passages.
19 - Before disconnecting the hoses, check that they are no more under pressure and that the power
supply is off.
20 - The personnel involved in the electrostatic coating system servicing must be trained and qualified. If
you face any trouble which cannot be repaired, do not try to start up the equipment. Consult
immediately your local authorized KREMLIN distributor for assistance.
KREMLIN REXSON
Page 3
Manual : 573.149.112
Werbung
Inhaltsverzeichnis
