Petporte Smart Flap ® Quick Guide; Petporte Smart Flap ® -Schnellanleitung - Petsafe Petporte smart flap Montageanleitung

Petporte smart flap
Function
Normal Mode
Night Mode (Timer Mode)
Vet Mode
Program Entry
Extended Modes
Key Pad Lock
Erase Mode
Reset to Normal Mode
Quick Guide
®
Button Activation
This is the default mode on powering up and
requires no button activation.
Press the Red Button for less than 2 seconds
Press the Red Button for more than 5 seconds
Press and hold the Green Button for more
than 10 seconds
Press and hold both the Red and Green
Buttons for more than 2 seconds
Press and hold the Red Button for more than
30 seconds
Press and hold both the Red and Green
Buttons for more than 30 seconds
Press and hold the Green Button for more
than 30 seconds
Replacement flaps available online
Mode Button Function
The red light will illuminate.
In Night Mode: During the hours of darkness, the green light will
illuminate. The unit will not allow the cat to exit. At dawn, the green
light will extinguish and the lock opens and the cat can go outside
again until dusk.
In Timer Mode: The unit will Lock and Unlock at specific
programmed times of day.
The red light will then flash and the unit will not allow any cats to
go out.
The green light will flash and you then have 30 seconds in which to
program your cat by passing the animal under the porch.
The unit will emit a long beep indicating that the extended modes
are now available and the green light will be lit. (See the Extended
Modes - Quick Guide on page 14)
The unit will emit a series of beeps indicating the unit is now locked.
The unit will emit a series of short beeps followed by a long beep.
Both lights should now be flashing.
Note: Once the unit's memory has been erased, it will have to be
re-programmed before further use!
The unit will emit a series of short beeps followed by a long beep.
Both lights should extinguish.
13