Petsafe Petporte smart flap Montageanleitung Seite 12

Fig. 9
Click the small cover plate back
over the interior section.
Fig. 11
When fitting the Petporte smart
flap ® into an opening offer the
interior section with Extension
Tunnel if needed up to the opening.
Next pass the porch cable from the
porch and exterior section through
the rectangular opening in the
interior section.
12
Fig. 10a
Power up the Petporte smart flap
®
program in your cat as shown on
page 7, and pass the Petporte smart
flap over your cat at a distance that
®
your cat would normally approach it
to check that will work for your cat.
Fig. 12a
Fig. 12b
Attach the porch cable to the
electronics board and hold the exterior
and interior sections together using
the two M6 screws. Tighten the screws
to hold the Petporte smart flap in the
®
desired position within the opening.
www.petsafe.net
Fig. 10b
,
Alternatively you can hold the
Petporte smart flap
orientation for the purpose of
programming your cat's microchip.
Fig. 13
Once positioned, attach the large
cover plate and secure with the four
self-tapping fixing screws. Click in
place the small cover plate. Place
all of the blanking plugs, four small
ones for the self-tapping fixing screws
and two large blanking plugs for the
M6 screws. Finally, power up your
Petporte smart flap
in an inverted
®
.
®