Precautions For Use - Chauvin Arnoux MiniFLEX MA193 Bedienungsanleitung

Thank you for purchasing a MiniFLEX MA193 flexible current sensor. For best
results from your instrument:
„ read these operating instructions carefully,
„ comply with the precautions for use.
WARNING, risk of DANGER! The operator must refer to these instruc‑
tions whenever this danger symbol appears.
Equipment protected throughout by double or reinforced insulation.
Must not be applied to or removed from conductors at dangerous
voltages. Type B current sensor as per IEC 61010‑2‑032.
The CE marking indicates conformity with European directives, in
particular LVD and EMC.
The rubbish bin with a line through it indicates that, in the European
Union, the product must undergo selective disposal in compliance with
Directive WEEE 2002/96/EC. This equipment must not be treated as
household waste.
Definition of measurement categories:
„ Measurement category IV corresponds to measurements taken at the source of
low‑voltage installations.
Example: power feeders, counters and protection devices.
„ Measurement category III corresponds to measurements on building installations.
Example: distribution panel, circuit‑breakers, machines or fixed industrial devices.
„ Measurement category II corresponds to measurements taken on circuits directly
connected to low‑voltage installations.
Example: power supply to electro‑domestic devices and portable tools.
This sensor is protected against voltages that do not exceed 1,000 V in relation to
the earth in CAT III or 600 V CAT IV between the sensor and the conductor whose
current it is measuring.
The protection provided by the instrument may be impaired if the instrument is used
other than as specified by the manufacturer.
„ Do not exceed the rated maximum voltage and current or the measurement
category.
„ Observe the conditions of use, namely the temperature, the relative humidity, the
altitude, the level of pollution, and the place.
„ Do not use the sensor if its casing is open, damaged or incorrectly reassembled.
Before each use, check the integrity of the coil insulation.
„ Use suitable personal protective equipment when parts at hazardous voltages
may be accessible in the installation where the measurement is made.
ENGLISH

PRECAUTIONS FOR USE

8