Before Using The Appliance - Unold 78856 Bedienungsanleitung

plug out of the socket and
adjust the cutting width to
0.
25. Please avoid any contact
between the power cord and
the knife or any other sharp
edges.
26. The knife is very sharp, be
very cautious when cleaning
it!
27. Inexpert
repairs may entail serious
risks to the user. Repairs
should only be performed by
our after sales service.
28. The slicer is provided for
domestic use and is not
suitable
use. Only use it for slicing
household quantities.
29. Do not use the appliance
with accessories of other
manufacturers or brands, to
prevent damage.
Caution! The knife is very sharp, risk of injuries!
Never open the housing of the appliance. This can result in electric shock.
The manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

BEFORE USING THE APPLIANCE

1. Remove all packaging materials
and check, if all parts are com-
plete.
2. Before using the appliance for the
first time, wipe it with a damp
cloth (see chapter Cleaning)
3. Place the slicer on a flat, clean,
solid, and dry surface.
4. Mount both parts of the carriage.
5. Insert the carriage into the guide.
Hold it at a right angle and then
tilt it downward.
handling
for commercial
30. Disconnect the appliance
from the wall socket after
use and prior to cleaning.
Never leave the appliance
unattended when it is con-
nected to the wall socket.
31. Never open the casing of
the slicer. There is danger of
electric shock.
32. Check the appliance, the
and wall socket and the lead
cable regularly for wear or
damage. In case the lead
cable or other parts appear
damaged, please send the
appliance or the base to our
after sales service for ins-
pection and repair. Unautho-
rised repairs can constitute
serious risks for the user and
void the warranty.
6. Place the rest holder on the carri-
age and the food tray from the left
side under the carriage.
7. Put the plug into a power socket
as per rating label.
8. Adjust the desired cutting thick-
ness from 0–15 mm by turning
the wheel.
17