Cleaning The Spray Arms; External Cleaning; Troubleshooting - Atag VA6311SF Benutzerinformation

Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

External cleaning

Clean the appliance with a moist soft cloth.

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
6. Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
•
- The appliance does not drain the
water.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
25