Running The Cleaning Program; Running The Descaling Program - AEG Electrolux CP 2 Serie Gebrauchsanweisung

822_949_318 CP2..._defnep.book Seite 42 Freitag, 2. November 2007 6:30 18
g
The ejector lever flips in and the cof-
fee-making unit closes.
Inserting the coffee-making unit
0 Follow these steps to re-insert the cof-
fee-making unit:
1. Push the coffee-making unit onto the
guide bar and then unit into the coffee
machine as far as it will go (Fig. 36).
2. Press the latching button down and
slide the coffee-making unit back for
around another 1 cm until the latching
button engages (Fig. 37).
3. Press the latching lever down to the
stop (Fig. 37).
0 Replace and close the service cover,
and re-insert the coffee grounds con-
tainer.
3 The coffee machine can be switched on
only when the service cover is closed.
After the coffee machine has been
switched on, the coffee-making unit
runs through the set-up cycle, and this
is followed by the normal heating pro-
cess.

15.6 Running the Cleaning Program

The cleaning program permits the
intensive cleaning of otherwise inac-
cessible locations. Run the cleaning
program no later than when the
"Clean" key (Fig. 3, f)
flashes.
The cleaning process lasts around
8 minutes and should not be inter-
rupted.
Use only original AEG-cleaning tablets!
3
These can be obtained through the
AEG Serviceline (ET No. 663 910 480) or
your dealer (E No. 950 078 803).
0 Before starting the cleaning program,
clean the coffee-making unit (refer to
„Cleaning the Coffee-making Unit"
page 41) and empty the coffee grounds
container. Fill the water tank with at
least 1 litre fresh water.
0 Press the "On/Off" key (Fig. 3, h)
switch the coffee machine on.
0 Turn the coffee bean container to the
"Ground Coffee" position
Wait until the mechanism has set up
42
and all the lights of the Coffee Quan-
tity indicator are extinguished.
0 Pull the emptied grounds container out
until it is under the coffee dispenser
(Fig. 39).
It is used to collect the cleaning liquid.
The "Empty grounds container" indica-
tor (Fig. 3, j)
illuminated for as long as the grounds
container is pulled out.
0 Place a cleaning tablet in the ground
coffee filler (Fig. 40).
0 Press the "Clean" key (Fig. 3, f)
around 3 seconds. The indicator
changes from flashing to constantly
on. The program starts. The cleaning
program must not be interrupted.
3 During the cleaning process, the
"Empty grounds container" indicator
(Fig. 3, j)
Coffee Quantity indicators are illumi-
nated alternately. The program runs six
cycles with cleaning liquid. The stand-
ing times are used to allow the clean-
ing tablet to penetrate. In the event of
a power failure or interruption, the
program must be restarted!
The cleaning process finishes after
approximately 8 minutes, when the
Coffee Quantity indicators are extin-
indicator
guished and the "Empty grounds con-
tainer" indicator (Fig. 3, j)
0 Empty the coffee grounds container
and re-insert it. The
now goes out.
0 Turn the coffee bean container to the
desired position and fill the water tank.
The coffee machine is now ready for
use.
3 After running the cleaning program,
you are advised to throw away the first
cup of coffee from the machine.

15.7 Running the Descaling Program

The descaling program allows you to
to
simply and effectively descale your
coffee machine. The coffee machine
must be descaled when the "Descale"
key (Fig. 3, e)
(Fig. 38).
the latest however after 4 months.
comes on and remains
for
is illuminated, and the
flashes.
indicator light
indicator flashes, at