Tips For Making Hotter Coffee; Running The Rinsing Program; Making Several Cups Of Coffee With The Jug Function - AEG Electrolux CG 6400 Gebrauchsanweisung

g
water from the steam nozzle for a few
seconds.
3 When using the appliance for the first
time, at least 4-5 cups of coffee need
to be made before the appliance starts
to yield satisfactory results.
7.1

Tips for making hotter coffee

• When you turn the appliance on, if
you want to make a short coffee
(less than 60 ml), use the hot rinse-
through water to preheat the cups.
• Set a higher coffee temperature in
the corresponding menu; see „Set-
ting the coffee temperature",
page 47.
• If you have not dispensed coffee for
a long period of time with the
machine switched on, you should
rinse the system before dispensing
again, to pre-heat the brewing unit.
Select the rinsing function in the
corresponding menu (see „Running
the rinsing program", page 42). Run
off the water into the underlying
drip tray, or alternatively use this
water to fill (and then empty) the
cup to be used for the coffee, so as
to pre-heat the cup.
• Unless they have been pre-heated,
do not use cups that are too thick, as
they will absorb too much heat.
• Use cups that have been pre-heated
by rinsing them with hot water or by
leaving them for at least 20 minutes
on the heated cup rack (H) with the
coffee machine on.
7.2

Running the rinsing program

The rinsing program allows the brew-
ing unit and dispenser to be heated up.
The rinsing process takes only few
seconds.
0 Press the "Menu" key (Fig. 4). The menu
item «CHOOSE LANGUAGE»
appears.
0 Press the scrolling keys "<" or ">"
(Fig. 5) until the menu item
«RINSING» appears.
42
0 Confirm the menu item with the "OK"
key (Fig. 5). The display shows
«RINSING», and an advancing
progress bar with a percentage indica-
tion «
After rinsing, the machine returns
automatically to the coffee mode.
8 Making several cups of
coffee with the jug
function
This function allows you to make sev-
eral cups of coffee completely auto-
matically, which are poured into the
stainless steel thermos jug that is
supplied: Grinding, portioning, press-
ing, pre-brewing, brewing and ejection
of the coffee grounds are as described
in the previous section.
The appliance is preset to make coffee
of normal strength and in a medium
cup size. You can also set your pre-
ferred cup size and strength as
described in the section „Setting the
jug program (coffee strength and fill
level for jug function)", page 47.
0 Turn the lid of the stainless steel ther-
mos jug to the position for removal
(Fig. 17), and take the lid off the jug.
Rinse both the lid and the thermos jug.
0 Place the thermos jug under the coffee
dispenser (D), with the lid in position
for pouring (fig 18). The dispenser must
be slid up fully to allow the jug to be
pushed in.
The display shows continuosly «FILL
BEAN CONT. AND WATER
TANK, EMPTY WASTE CONT.,
PRESS OK» to remind you of the
basic operations that are necessary in
order to allow the preparation of a
series of coffees for the jug.
0 After having checked that the water
tank is full, the bean container has
enough coffee beans, and the waste
coffee container is empty, press the
"OK" key (Fig. 5).
40%».