Installation Of The Oven - Indesit FM 54 RK.A Handbuch

INSTALLATION OF THE OVEN

The oven can be built into a standard 560mm housing unit (see drawings at the
beginning of the booklet), either when built under the worktop or built in a tall housing
unit.
In both cases ventilation provisions must be made; for this reason, there must be a gap
of 85-90mm at the back of the housing unit.
The fixing of the oven in the cabinet is made by 4 screws A that are on the
corners of the oven door frame.
When placing the appliance in the housing unit, do not use the oven door as a lever for
lifting the oven.
To open the oven door, always pull the handle in the middle.
Do not place heavy objects on or lean on the oven door when open, as this can cause
damage for the hinges.
BEFORE USING THE OVEN
Attention: the oven must be unplugged from the electrical mains. Before using the oven,
carefully clean the interior, the racks and the drip pan with non-abrasive soap and
lukewarm water. Insert the racks and the drip pan into their respective runners. When this
operation is complete, plug the oven into the electrical mains and bring it up to maximum
temperature for at least 20 minutes in order to eliminate any residual grease, oil or resins
from manufacturing which may cause unpleasant odours during cooking; then ventilate
the room.
Once completed this simple operation, the oven is ready to cook for the first time.
26