After Use; Cleaning And Maintenance - Termozeta Milordino Gebrauchsanweisung

ENGLISH
• Connect the plug to the power outlet and move the iron over an old
cloth to remove all the water remaining in the soleplate.
WARNING!
Do not come into contact with the water coming out of the soleplate,
since it is very hot and could cause burns.
NOTE: Before using the iron again, pass the cold soleplate on a dry
cotton cloth.

AFTER USE

• Disconnect the plug from the power outlet.
• Empty the tank.
• Always set the steam control dial (4) to the "0" position.
• Let the iron cool down.
• Wind the cord around the rear part of the appliance.
• Place the iron vertically.

CLEANING AND MAINTENANCE

WARNING!
Before carrying out any cleaning operation disconnect the plug
from the power outlet and wait until the iron has completely cooled
down.
• Clean the iron body only with a soft and dry cloth.
• Clean the soleplate using a non-abrasive sponge in order not to
damage the surface.
• Do not use chemical or abrasive substances.
• Do not immerse the appliance in water or other liquid substances.
Termozeta S.p.A. reserves the right to introduce technical and/or aesthetic changes
Termozeta is an international trademark. Copyright © 1995. All rights reserved.
Termozeta S.p.A. - Via Magenta, 41/43 - 20010 Bareggio (MI) Italy
to its products intended to improve performances.
www.termozeta.com