Werbung
•
•
• ENGLISH
GENERAL SAFETY REQUIREMENTS
• This booklet is an integral part of the appliance and must be carefully
read before use since it provides important information on the
installation, safety, use and maintenance of the appliance. Keep in a
safe place.
• After removing the packaging make sure the appliance is undamaged and
that no parts are missing. If in doubt, do not use and contact an authorised
TERMOZETA service centre.
• Do not leave parts of packaging (plastic bags, foam polystyrene, nails, etc)
within reach of children or unqualified persons since they are potential
sources of danger.
• If the appliance comes with an earth plug, the electrical safety is ensured
only when this plug is correctly connected to an effective earthing system
in compliance with the existing electrical safety standards. TERMOZETA
shall not be held responsible for any damages caused by the lack of a
correct earthing system.
• Before connecting the plug to the power outlet make sure the operating
voltage of the appliance corresponds to the voltage of your mains supply.
If in doubt, contact a qualified technician.
• Do not use adaptors, multiple plugs and extension leads. If necessary, only
use devices that conform to the current safety standards making sure they
are compatible with the power of the appliance. If in doubt, contact a
qualified technician.
• Any installation not conforming to the above instructions may
compromise the safety of the appliance and cancel the guarantee.
• The appliance was exclusively designed for domestic use to iron fabrics.
• For safety reasons:
- do not use the appliance with bare feet and wet hands or feet
- do not use the appliance outside the home
- do not leave the appliance exposed to atmospheric agents (sun, rain...)
- do not let children or unqualified people use the appliance
- never pull on the power cord or on the appliance itself to disconnect the
plug from the power outlet
- do not leave the appliance unattended when it is plugged into the mains
power
- never immerse the appliance in water or other liquids.
• The power cord of the appliance must not be replaced by the user. If
necessary, contact an authorised TERMOZETA service centre or qualified
technician.
• Switch off and do not tamper with the appliance should it breakdown
and/or not function properly. Contact an authorised TERMOZETA service
centre for any repairs and ask for original spare parts.
• Make the appliance unserviceable at the end of its running life by
unplugging it from the power outlet and cutting the power cord. Abide by
the existing standards in your country for instructions on its disposal.
• Termozeta shall not be held responsible for any damages to persons,
animals or objects caused by incorrect installation or due to improper,
incorrect and negligent use.
INSTRUCCIONES DE USO
DESCRIPCIÓN MANDO DE REGULACIÓN DE VAPOR (4)
Tabla A
FUNCIÓN
Planchado en seco
DESCRIPCIÓN
No vapor
FUNCIÓN
Planchado con vapor
DESCRIPCIÓN
Nivel vapor: intermedio
FUNCIÓN
Planchado con vapor
DESCRIPCIÓN
Nivel vapor: máximo
GUÍA DE PLANCHADO
Tabla B
• max
Planchado con vapor máximo
•••
Planchado con vapor a temperatura alta (algodón, lino)
••
Planchado a temperatura media (lana, seda)
•
Planchado a temperatura baja (fibras sintéticas)
■
LLENADO DEL DEPÓSITO
• Lleve siempre a cabo esta operación con la clavija desconectada de la
toma de corriente.
• Asegúrese de que el mando de regulación de vapor (4) esté en la posición de
planchado en seco (consultar tabla A).
• Abra la tapa (2) y llene el depósito a través del correspondiente orificio, sin
superar el nivel MAX (11) indicado en el propio depósito. No introduzca
nunca sustancias perfumadas en el depósito.
• Cierre de nuevo la tapa (2).
Consejos:
Si el agua de su zona es especialmente dura, se recomienda utilizar agua
destilada.
PUESTA EN MARCHA
• Compruebe que el mando de regulación del vapor (4) esté en la posición de
planchado en seco (consultar tabla A).
• Desenrolle completamente el cable de alimentación (7), coloque la plancha en
posición vertical y conecte la clavija a la toma de corriente.
• Con el mando de regulación de la temperatura (9), seleccione la temperatura
idónea para el tipo de tejido que vaya a planchar (consultar tabla B).
• La luz piloto del termostato (8) se enciende, y se apagará cuando la placa haya
alcanzado la temperatura seleccionada. En este momento la plancha está lista
para su uso.
Importante:
• No deje nunca la plancha sin vigilancia cuando esté conectada a la toma
de corriente
Consejos:
• planche en primer lugar los tejidos más delicados, que requieren bajas
•
•
• ESPANÕL
Werbung
