Roger Beep On/Off; Button Lock; Display Back Light; Earpiece Connection - UCOM Twintalker 4710 Bedienungsanleitung

UCOM Twintalker 4710 DCP

14.17 Roger Beep On/Off

After the PTT - button
have stopped talking.

14.18 Button Lock

The Button Lock is not valid for the
14 and the PTT- button

14.19 Display back light

To activate the backlight of the LCD display, press any button except the PTT- button
the button 7 .
The LCD backlight will light up for 5 seconds.

15 Earpiece connection

The Twintalker 4710 can be used with the included earpiece.
The connector is located under the protective rubber cover on the right side of the unit
To attach the earpiece, remove the rubber flap to expose the connector.
Insert the earpiece plug into the connector (2,5mm jack).
The small button on the earpiece has the same function as the PTT button
When you use the PTT - Button from the Earpiece, you must also use the microphone from
the earpiece wire.
Do not connect other earpieces. This may damage your device.
16
13 is released, the unit will send out a roger beep to confirm that you
• Press the - button
setting flashes on the display.
• Press the - button
disable (OF) the Roger Beep.
• Press the PTT- button
mode.
• Press and hold the
Button Lock mode. The Button Lock icon is displayed on the LCD
Screen.
• Press and hold the
Lock.
13
5
eleven times, the current Roger Beep
11 or the
13 to confirm and return to stand-by
- button 12
- button 12
- button
.
6
- button to enable (ON) or
for 3 seconds to activate the
again to deactivate Button
9 , the -button
13
UCOM Twintalker 4710 DCP
13 or
.
4
on the unit