Using The Twintalker 4710; Turning The Unit On/Off; Adjusting Speaker Volume; Receiving A Signal - UCOM Twintalker 4710 Bedienungsanleitung

UCOM Twintalker 4710 DCP

14 Using the Twintalker 4710

14.1 Turning the Unit ON/OFF

14.2 Adjusting Speaker Volume

14.3 Receiving a Signal

The unit is continuously in the RECEIVE mode when the unit is switched ON and not
transmitting.
In order for other people to receive your transmission, they must also be
on the same channel and have set the same CTCSS code. (See chapter
14.5 and 14.6)

14.4 Transmitting a Signal

To check the channel activity use the monitor function (See chapter
14.7). The maximum transmitting time is limited to 1 minute. Release and
press PTT - button
10
To turn ON:
• Press and hold the
"beep" and the LCD display will display the current channel.
To switch OFF:
• Press and hold the
"beep" and the LCD display will turn blank.
• Press the - button
speaker volume. The volume level is displayed.
• Press the - button
• Press and hold the PTT - button
symbol is displayed.
• Hold the unit in a vertical position with the MICROPHONE 10cm
from the mouth and speak into the microphone.
• Release the PTT - button
transmitting.
to restart transmitting.
13
- button 14 for 2 seconds. The unit will
- button 14 for 2 seconds. The unit will
11 in stand-by-mode to increase the
to decrease the speaker volume.
6
to TRANSMIT. The TX
13
when you want to stop
13
UCOM Twintalker 4710 DCP