Changing Channels; Ctcss (Continuous Tone Coded Squelch System); Monitor; Baby Monitor Function - UCOM Twintalker 4710 Bedienungsanleitung

14.5 Changing Channels

If no button is pressed within 5 seconds during setting, the unit will return
to standby.

14.6 CTCSS (Continuous Tone Coded Squelch System)

The 2 digit CTCSS code corresponds to a specific tone frequency the radio emits. Two users,
with the same channel and CTCSS set can hear one another.They will not be able to hear
anyone else on the channel unless the other radios have the same exact CTCSS code
enabled. The Twintalker 4710 has 38 CTCSS codes available.
• Any PMR set on the same channel can receive and listen to the
conversation, also when the other use a CTCSS code.
• To disable CTCSS code, set the code to '0'.

14.7 Monitor

You can use the monitor feature to check for weaker signals in the current channel.
• Press and hold the
• Release the -button

14.8 Baby Monitor function

One of the units can be set as Babymonitor. The radio will transmit a signal when it is
activated by the crying baby or another sound in the room (VOX).
The PMR will no longer be able to receive signals to avoid that your baby is disturbed during
his sleep.
The other PMR must be set to the same channel and CTCSS code to receive the signal from
the Baby Monitor.
UCOM Twintalker 4710 DCP
• Press the - button
flashes on the display.
• Press the - button
channel.
• Press the PTT - button
mode.
• Press the - button
flashes on the display.
• Press the - button
another code.
• Press the PTT - button
mode.
-button 9 to activate channel monitoring.
9 to stop monitoring.
5
once, the current channel number
11 or the - button
to confirm and return to stand-by
13
5
twice, the current CTCSS code
11 or the - button
to confirm and return to stand-by
13
UCOM Twintalker 4710 DCP
to change the
6
to change to
6
11