Channel Scan; Dual Channel Scan - UCOM Twintalker 4710 Bedienungsanleitung

UCOM Twintalker 4710 DCP

14.12 Channel Scan

Channel scan performs searches for active signals in an endless loop from channel 1 to 8
including the CTCSS codes
• When you start the Channel Scan function when your CTCSS - code
is set to '0', the PMR will search for all signals (with or without
CTCSS - code).
• When you start the Channel Scan function when you have set a
CTCSS - code (1 - 38), the PMR will only search for signals with
CTCSS - code. Signal without CTCSS - code will be ignored.

14.13 Dual Channel scan

In stand-by, the PMR is set on one set channel with CTCSS code. The PMR will only receive
signals transmitted on that channel and CTCSS code.
Dual Channel Monitor allows you to monitor a second channel with CTCSS code.
Press the -button
or the - button
When the Dual Channel Monitor function is activated, the PMR will switch sequentially
between the standby channel + CTCSS and the Dual Channel + CTCSS.
When there is activity on the Dual Channel + CTCSS, the active channel will be displayed
for 5 seconds after the activity has ended. Within this period, you have the posibility to answer
the transmission.
14
.
• Press the
channel scan icon is displayed.
• When an active signal (one of 8 channels) is detected, press the
PTT - button
over the active channel. If you don't press the PTT - button
Channel Scan will restart after 5 seconds.
• Press the
current channel and continue to search for another active
channel.
• Press the
• Press the
icon appears on the display.
• Press the
channel.
• Press the
go to CTCSS SUB-CHANNEL SELECTION.
• Press the
CTCSS.
• Press the PTT - button
mode.
5
seven times to disable the function. Then press the
6
until 'OF' is displayed.
- button 9 briefly to activate Channel Scan. The
13 to fix the channel and starts communicating
11
- button or the
- button 9 briefly to deactivate Channel Scan.
5
- button seven times, the dual channel scan
- button 11 or the
5
- button to confirm the channel selection and
- button 11 or the
13 to confirm and return to stand-by
6
- button to bypass the
6
- button to change the
6
- button to change the
UCOM Twintalker 4710 DCP
13 ,
- button 11