Technical Specifications; Care And Maintenance - Kärcher WD 3 Originalbetriebsanleitung

Note: As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.
Blowing function
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
Finish operation
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.

Care and maintenance

 Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
 If required, rinse the container and accessories
with water properly and dry them before reuse.
Illustration
 Only clean the cartridge filter under running water;
do not wipe or brush. Let it dry completely prior to
installation.
Troubleshooting
Decreasing cleaning power
If the cleaning power of the appliance deteriorates
please check the following:
 Accessories, suction hose or suction pipes are
clogged, please remove the obstruction using a
stick.
Illustration
 Filter bag is full, install new filter bag.
Illustration
 Cartridge filter is dirty, knock off dirt from cartridge
filter and clean under running water if necessary.
 Replace damaged cartridge filter.
14

Technical specifications

The Specifications are listed on page IV. The following
is an explanation of the symbols.
Voltage
Output P
Max. connection output of appliance
socket
Mains fuse (slow-blow)
Container capacity
Water intake with handle
Water intake with floor nozzle
Power cord
Sound pressure level (EN 60704-2-1)
Weight (without accessories)
Subject to technical modifications!
– 9
EN
nom