Working With The Blender - Silvercrest SKV 1200 A1 Bedienungsanleitung

Working with the blender

WARNING! RISK OF INJURY!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx. 30–40°C)
before adding them into the blender
WARNING! RISK OF INJURY FROM
SHARP BLADES/ROTATING DRIVE
UNIT!
► Never put your hand into the attached
blender !
► Do not remove the blender
blades are stationary.
► Operate the blender
lid with the measuring cup
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket
to prevent the appliance from being switched
back on unintentionally.
ATTENTION! PROPERTY DAMAGE!
► Never use the mixing bowl
at the same time! This will overload the motor!
► When working with the blender
mend allowing the appliance to cool down
after 3 minutes of operation.
Proceed as follows to prepare the blender for
operation . Use figure C on the rear fold-out
page as a guide.
1) Press down the release lever
swivel arm downwards into the working
position.
2) Turn the drive protection cover
that the arrow on the drive protection cover
is pointing to the
Remove the drive protection cover
place it to one side.
■ 8 │ GB │ CY
.
unless the
only when the blender
are attached.
and blender
we recom-
and press the
clockwise so
symbol on the appliance.
and
WARNING! RISK OF INJURY!
► Ensure that the rotary switch
"0" before you place the blender
blender drive . Otherwise the appliance will
start immediately as soon as the blender
has locked into place.
3) Place the blender
so that the lock tabs on the underside of
the blender lock into the recesses on the
blender drive unit
blender must be pointing to the
on the appliance. Turn the blender
clockwise as far as it will go. The
on the blender must then be pointing to the
symbol on the appliance.
4) Add the ingredients.
5) Place the blender lid
in position so that the lips of the blender lid
also seal the spout.
6) Turn the rotary switch
NOTE
► The ideal speed depends on the consistency
of the items being mixed. The more liquid the
contents are, the faster you can mix them.
► For short, powerful pulsed operation, turn
the rotary switch
Level P does not lock into place so as not
to overload the motor. You should therefore
keep the rotary switch
for a short time.
CRUSHING ICE
► In order to produce crushed ice, place ice
cubes in the blender
rotary switch approx. 7 times to level P
for 5 seconds. You may need to adapt the
above instructions depending on the quantity
and size of the ice cubes.
is turned to
on the
on the blender drive unit
. The symbol on the
symbol
anti-
symbol
with measuring cup
to the desired setting.
anticlockwise to level P.
in this position only
, close it and turn the
SKV 1200 A1