C) Connection Of The Endoscope Camera - VOLTCRAFT BS-350XIPSD Bedienungsanleitung

c) Connection of the endoscope camera

Now connect the enclosed endoscope camera to the BS-350XIPSD.
• If you have switched on the device, switch it off again at first (see
chapter 8 d).
• Push the plug of the camera C3 into the connection a1 of the endo-
scope (see arrow).
The proper orientation can be told by the guide pin in the plug. When
the endoscope is display-up, the pin must also still point up.
When pushing on, ensure that you do not bend or break off any pins.
• Turn the closure of the camera plug counter-clockwise (see arrow) until
it is tightened hand-tight.
The camera plug must no longer move then.
To remove the camera again, switch off the BS-350XIPSD first and screw open the
metal closure again (turn -clockwise). Then remove the camera.
37