Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - Einhell Rg-Es 1639 Bedienungsanleitung

Anleitung_RG_ES_1639_SPK1:_
GB
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
A worn out or damaged cutting unit should be
replaced by an authorised expert (see adress on
the warranty certificate).
Take care that all fastening elements (screws,
nuts, etc.) are firmly tightened, so that you can
work safely with the scarifier.
Store the scarifier in a dry place.
For longer life, all screw-fastened parts, such as
wheels and axles should be cleaned and
subsequently oiled.
Regular servicing of the scarifier not only
secures longer endurance and performance, but
also contributes to an accurate and simple
scarification of your lawn.
At the end of the season, carry out a general
check of the scarifier, and remove all residue
collected. Before the start of every season, it is
absolutely necessary to check the state of the
scarifier. Contact our Customer Service (see
address on the warranty certificate) if repair work
is necessary.
16
18.09.2008 10:56 Uhr Seite 16
8.4 Replacing the spike drum
For safety reasons, we recommend having the spike
drum replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear work gloves!
Only replace the unit with a genuine Einhell spike
drum , as this will ensure top performance and safety
under all conditions.
8.5 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Replacement cutting unit Art. No.: 34.211.07

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.