Clearaudio Matrix Bedienungsanleitung Seite 9

Finally, gently tighten the screw. The cleaning arm is now
reassembled.
3.4 Please connect the silicon fluidtube to the "Pure Groove"
Matrix.
before using the
3.5 While putting back the cleaning arm, please take care
that the silicon tube is behind the cleaning arm device.
Please only lightly tighten the secure lock screw, so that the whole
cleaning arm can be moved very easily.
3.4 Releasing & cleaning the vacuum hose
It is also possible to clean the vacuum hose and the
microfabricpads.
If you want to change the microfabricpads, please go on with 3.1
– 3.3. You will need two pads for the vacuumhose!
3.5 Button cap cleaning
It may happen that some condensated fluid appears on the inner
surface of the switch covers if too much cleaning fluid has been
spilled on the machine. They can easily be cleaned by removing the
silicon cover switch.Don´t forget to put them back!
Please note that, the switch covers are waterproof but not
waterresistant! Never spill fluid into the switch, the Matrix may be
damaged!
Page 9
Matrix
User manual / Bedienungsanleitung
Picture 17: Tighten the screw
Picture 18: Connecting the fluidtube to the
"Pure Groove"
Picture 19: Tighten the secure screw
Picture 20: Cleaning the vacuum hose
Picture 21: Cleaning the vacuum hose
Picture 22: Cleaning butoon cap
 clearaudio electronic GmbH 2007