Clearaudio Matrix Bedienungsanleitung Seite 5

2. Set up
1. Carefully take out the Matrix and place it on a stable,
water resistant surface.
2.
Please remove the cleaning fluid cap (cf. picture no. 2) to
fill the Matrix with a cleaning liquid of your choice.
(Warning: Use non foaming cleaning fluid only!!).
results clearaudio recommends our highly effective and
antistatic clearaudio cleaning liquid. The storage container
can be filled with cleaning liquid up to a maximum of 0.8
litres. Please ensure that an overflow is avoided by
checking the fill-level. Please close the fluid-storage-
container with the fluid cap afterwards
3. Please connect the Matrix to the 110V Trafo and
afterwards the Trafo to the main power. Now place the
record to be cleaned on the platter of the Matrix and fix the
LP with the recordclamp (TWISTER).
TIP : The cleaningbrush, which is fixed in the movable arm,
can be moved horizontally and to the required position. After
adjusting fix the cleaning brush with the locking screw.
4. Important note:
Vacuum unit outlet hose with the hose blocking clamp
(which is shown on picture no. four). An open hose will
cause a vacuum in the container, which can lead to used
fluids being returned to container resulting in an overflow
and possible damage!
Page 5
Matrix
Before using the
Picture 1: Placing the Matrix
For best
Picture 2: Filling up the container
Picture 3: Moving the cleaning arm
close the
 clearaudio electronic GmbH 2007
Matrix
User manual / Bedienungsanleitung
Picture 4: Closing the vacuum unit!