VOLTCRAFT VC-110 Bedienungsanleitung Seite 33

The unauthorized conversion and/or modification of the product is inadmissible for reasons of safety and
approval (CE).
Consult an expert when in doubt as to the operation, the safety or the connection of the device.
meters and accessories are not toys and have no place in the hands of children.
On industrial sites, the accident prevention regulations of the association of the industrial workers'
society for electrical equipment and utilities must be followed.
In schools, training centres, computer and self-help workshops, handling of meters must be supervised
by trained personnel in a responsible manner.
The device is equipped with a class 2 laser according to EN 60 825-1: 1994. The device includes self-
adhesive warning signs in different languages. Attach the sticker in your language to the device.
The laser aperture is marked with the triangular laser caution label. Never look into the laser beam and
never point it at people or animals. Laser radiation may lead to eye or skin injuries.
Do not point the laser beam at mirrors or other reflecting areas. The uncontrolled, deflected beam could
hit persons or animals.
If operating devices other than the herein stated or other procedures are used, this
can result in dangerous beam exposure.
Before measuring voltages, always make sure that the meter is not set to a measuring range for currents.
The voltage between the measuring instrument connection points and earth must never exceed 600 V
DC/AC in CAT III.
The measuring prods have to be removed from the measured object every time the measuring range is
changed.
Be especially careful when dealing with voltages higher than 50 V AC or 75 V DC. Even at these volta-
ges it is possible to receive a fatal electric shock if you touch electrical conductors.
Check the measuring device and its measuring lines for damage before each measurement. Never carry
out any measurements if the protecting insulation is defective (torn, ripped off etc.)
To avoid electric shock, do not to touch the connections/measuring points directly or indirectly during measu-
rements. During measuring, do not grip beyond the grip range markings (which you can feel) present on the
measuring prods.
Do not use the multimeter just before, during or just after a thunderstorm (lightning! / high-energy over-
voltage!). Please make sure that your hands, your shoes, your clothing, the floor, switches and switching
components are dry.
Caution
LASER RADIATION
DO NOT STARE INTO THE BEAM
CLASS 2 LASER PRODUCT
Output: max. 1 mW
Wavelength: 630-670 nm
EN 60 825-1:1994+A11:1996+A2:2001+A1:2002
33