Installing The Lcd Monitor - Dometic Waeco PerfectView M70IP Montage- Und Bedienungsanleitung

Installing the LCD monitor

7 Installing the LCD monitor
Tools required (fig. 1, page 3)
7.1
For installation and assembly, you will need the following tools:
z Measuring ruler (4)
z Centre punch (5)
z Hammer (6)
z Drill head set (7)
z Drill (8)
z Screwdriver (9)
To establish and test the electrical connection, the following tools are required:
z Diode test lamp (1) or voltmeter (2)
z Insulating tape (10)
z Heat shrinking sleeve
z Hot air blower (11)
z Crimping tool (12)
z Soldering iron (optional) (13)
z Solder (optional) (14)
z Cable bushing sleeves (optional)
To fasten the cables, you may require additional cable binders.
7.2 Installing the monitor
!
CAUTION! Beware of injury
Select the location of the monitor so that it cannot injure the passengers in the
vehicle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
z Select an installation location that provides an unobstructed view of the monitor
(fig. 6 and fig. 7, page 4).
z Never install the monitor in areas where your head could hit it or in the airbag deploy-
ment path. This could cause injury if the airbag opens.
z The monitor must not impair your vision when driving (fig. 8, page 5).
z The installation location should be flat.
z Check that there is sufficient space underneath the installation location to attach the
washers and nuts.
34
PerfectView M70IP
EN