Installing The Lcd Monitor - Dometic M70IP Montage- Und Bedienungsanleitung

Installing the LCD monitor

7 Installing the LCD monitor
Tools required (fig. 1, page 2)
7.1
For installation and assembly, you will need the following tools:
• Measuring ruler (4)
• Centre punch (5)
• Hammer (6)
• Drill head set (7)
• Drill (8)
• Screwdriver (9)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (1) or voltmeter (2)
• Insulating tape (10)
• Heat shrinking sleeve
• Hot air blower (11)
• Crimping tool (12)
• Soldering iron (optional) (13)
• Solder (optional) (14)
• Cable bushing sleeves (optional)
To fasten the cables, you may require additional cable binders.
16
PerfectView M70IP
EN