Replacing The Cutting Blades; Replacing The Fuse On The Transformer (11); Transport - AL-KO 127406 Betriebsanleitung

GB
Check the charging contacts of the base
station
1. Disconnect the mains plug.
2. Press the charging contacts in the direction
of the base station and release them. The
charging contacts must spring back into the
initial position.
Note: If the charging contacts do not spring
back, have them replaced by the AL-KO ser-
vice centre.
9.3

Replacing the cutting blades

CAUTION!
Danger of injury due to
the cutting blade
The cutting blades are
very sharp and can cause
cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of
the body do not get into
the cutting blade.
IMPORTANT!
Damage to the appliance
due to incorrect repair
The blade plate can be
damaged by the alignment
of a bent, built-in cutting
blade.
■
Do not align bent cutting
blades.
■
Replace bent cutting
blades by original spare
parts from AL-KO.
64
Worn or bent cutting blades must be replaced.
1. Switching off the appliance.
2. Put down the appliance with the cutting
blades pointing upwards.
3. Unscrew the fastening screws.
4. Take the cutting blade out of the blade seat.
5. Clean the blade seat with a soft brush.
NOTE
The cutting blades are sharpened along
the entire length and can therefore also
be mounted rotated by 180°, which dou-
bles their runtime.
6. Push in new cutting blades with the sharp-
ened side pointing towards the appliance.
Note: It is only allowed to use original spare
parts from AL-KO.
7. Insert the fastening screws again and firmly
tighten.
As a rule, the clearer blades do not need to be
replaced.
In case of stubborn dirt that cannot be removed
with a brush, the blade plate must be replaced
because an imbalance can lead to increased
noise levels, greater wear and malfunctions.
9.4 Replacing the fuse on the
transformer (11)
If the transformer no longer provides any current
although the mains voltage supply is intact:
1. Disconnect the transformer (11/2) from the
mains supply.
2. Unscrew the fuse cover (11/1) including the
fuse from the transformer (11/2).
3. Check the fuse. If defective, insert a new fuse
with the same rating (2.5 A, slow blow).
4. Insert the new fuse in the fuse cover.
5. Screw in the fuse cover including the fuse in-
to the transformer.

10 TRANSPORT

For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1. Stopping the appliance.
2. Switching off the appliance.
3. Lift the appliance by the carrier bar:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
Transport
Robolinho 4100